How many quarts e46 oil change

Guides Answers Contribute Contact. Difficulty Easy. Steps Time Required Sections 1. Flags 1. Featured Guide This guide has been found to be exceptionally cool by the site's staff.

Introduction Regular oil and filter changes are importants step in for the E46 M3's high-performance S54 engine. Make sure you always use the correct oil. You can purchase oil online or at your local BMW dealer. Add a comment. Add Comment Cancel. Step 2 Open Hood to the Engine Bay. Step 3 Disconnect the Throttle Position Sensor. Step 4 Remove the Oil Filter Cap. Step 9 Replace the Washer.

Step 10 Replace the Oil Filter. Step 11 Pour 5. Almost done! I heard also that the S54 holds about a quart in the engine after you drain it. Originally Posted by SeanMpower. Originally Posted by dwm. Not supposed to fill to the full mark in the S Stygar posted the service bulletin. Thanks guys. When I got home today I looked at the container and I actually added about 5. It's right at the top of the dipstick. I might drain some out then My last couple of oil change took 6 qt.

I was using Mighty vac. Bookmarks Bookmarks Digg del. Never work under a car supported only by a jack. The E46 M3 has four factory jack points two per side , but you can also jack up the car using these two center points one in front and one in the rear. Use this image for reference, but note that your exhaust configuration may look different. Note the oil filler cap the large black plastic cap on the left and the oil filter housing the metal cylinder with the star pattern top on the lower right.

Remove the bolt and set it aside. Some oil will drip, so have a shop rag or towel ready. Beneath the car, remove the small round plastic cover that hides the oil drain plug it's located in the middle of the aluminum underpanel, near the front center jack point.

Position your oil drain pan below the bolt so that it will catch the used oil as it flows out. The oil filter kit comes with a replacement washer sealing ring for the drain bolt.

Put the cap back on the oil filter housing, and torque the bolt down to 24 ft lbs. Check the oil level and top up as needed. The car should be level to the ground for an accurate reading. Close the hood and lower the car. Re-check the oil level after a short drive and top up as needed. Dispose of the old oil, filter, and any contaminated rags responsibly by taking them to a household hazardous waste facility. Many auto parts stores will also accept your used oil for disposal.

Cancel: I did not complete this guide. Badges: